Descriptions: Half-Bridge Experiments Body Scale Load Cell Sensor-50kg
50Kg Half-Bridge Experiments Body Scale Load Cell Sensor 50kg Cell Weighing Weight Sensor Strain Gauge Human Scale Load Cell Sensor Resistance Strain Tensile Strength Half Bridge
This is half bridge weight sensor (load cell) of measurements range up to 50 kg. It can be used for measuring weight, linear force or even thrust. The 50kg Half-bridge Experiments Body Scale Load Cell Sensor is measuring; the correct force is applied to the outer side of the strain E-shaped beam portion of the sensor (i.e., a strain gauge affixed to the intermediate, adhesive coating with white beam arms); and the outer edges to form a shear force in the opposite direction, i.e., middle strain beam bending necessary changes can occur under stress, strain beam side by another force should not be a barrier.
- Capacity (Kg): 50.
- Output Sensitivity (mv/v): 1.0±0.1.
- Nonlinearity (%FS): 0.03.
- Repeatability (%FS): 0.03.
- Input Resistance (Ω): 1000.
- Insulation Resistance (MΩ): ≥5000.
The sensor can be used with the following three methods
- Using a sensor with an external resistors full bridge measurement range of a sensor range: 50kg. Higher requirements for an external resistor.
- The uses of only two full-bridge sensors measuring range are the range of the two sensors and: 50kgx2 = 100kg.
- The use of four full-bridge sensors measuring range is the range of four sensors and: 50kgx4 = 200kg.
- Internal 1000Ohm half-bridge strain gauge load cell, the range is 50kg, half-bridge structure.
- Widely used in hopper scales, platform scales, platform balance, belt scales, and other electronic weighing devices.
- This is a half-bridge load sensor, which is widely used in weight scales. When the half-bridge is being stretched, it sends the signal via the red signal wire.
- Alloy Steel wired weighing load cell, high accuracy, simple structure, simple installation.
You can use multiple load sensors simultaneously to increase the capacity range, Parallel use to add additional capacity.
- Rated load: 50kg
- Rated output: 1.0 ±0.1mV/V
- Nonlinearity: 0.08 %F.S
- Hysteresis: 0.1 %F.S
- Repeatability: 0.05 %F.S
- Creep(5min): 0.05 %F.S
- Temperature Effect On Output: 0.02 %F.S/°C
- Temperature Effect On Zero: 0.02 %F.S/°C
- Zero balance: ±0.1000 mV/V
- Input impedance: 1000±20% ohm
- Output impedance: 1000±10% ohm
- Insulation resistance: 2000 Mohm
- Safe Overload: 120 %F.S
- Ultimate Overload: 150 %F.S
- Operating temperature range: -20~65°C
- Recommended Excitation Voltage: 5 VDC
- Maximum working voltage: 8VDC
- Level of protection: IP65
- Material: aluminium alloy
- Size: 34 mmx34mm
- 1 x 50Kg Half-Bridge Experiments Body Scale Load Cell Sensor 50kg Cell Weighing Weight Sensor Strain Gauge Human Scale Load Cell Sensor Resistance Strain Tensile Strength Half Bridge
There are no reviews yet.