DP30V5AL Programmable Power Supply Module

Descriptions: DP30V5AL Programmable Power Supply Module Step Down Regulator Constant Voltage Current Converter Digital LED Voltmeter

Technical parameters

• Input voltage range: 6-40.00V
• Output voltage range: 0V-32.00V
• Output current: 0-5,100A
• Output power range: 0-160W
• Product weight: 66g
• Product dimension: 85 * 58 * 31 (mm) (L * W * H)
• Output voltage resolution: 0.01V
• Output current resolution: 0.001A
• Output voltage accuracy: ± (0.5% + 1 digit)
• Output current accuracy: ± (1% + 3 digits)
• Rippled WAVE (40V to 32V / 5A full charge): approx. 100 mV VPP

Note: In the output state, the input must be 1 V greater than the output. Strengthens heat dissipation when working with large current.

Operating instructions

Open or close output: Press the ON / OFF button once to open or close the output in any State; press again, the outlet will close or open, followed by recycling. When the output is closed, the LED display will show “OFF”. two

Set output voltage and current: Press the Set shortly, the led display will flash. You can press the two buttons (+ Key and-key) on the left tube to increase or decrease the value. Press the SET key shortly again to change from 0.01V to 0.1V to 1V to 0.01A to 0.1A to 1A to exist the setting, followed by recycling. In the corresponding value place, you can press the two buttons (+ Key and-key) to increase or decrease the value. If you do not press the set key, the set mode will automatically go after 6 s and the current value will be saved automatically.

Display input and output switch: With no output status, press the two buttons on the left tube (key and exit key) to toggle the tube display between current input voltage and current output voltage. When the input voltage is displayed, the LED lights “IN”; When the output voltage is displayed, the “OUT” LED lights. 4

DC and CV indication: when the module is in constant voltage (CV) or constant current (DC) state, the CC or CV led will light according to the CV or CC state.

Zero calibration of the output current: in the no-load state, keep pressing the SET key to turn on, when the led display flashes, the calibration is done. Then you can loosen the SET key.

Store set value automatically: in the operation process, the status of the led display, the output current and the output voltage setting value and the output status are automatically stored. When powered on the next time, the default Job Status is the stored status.

Package Include:

• 1 x DP30V5AL Programmable Power Supply Module